Loading the pre-installed patches
M-64
MV-8800 Owner’s Manual
7.
Move CURSOR [ ] [ ] to the patch that you want to load and press [F5](Load).
The ASSIGN TO PART / LIBRARY popup (Screen Guide; p. 224) will appear.
8.
Specify the parameters.
•
Part
If the To parameter is set to “Part,” specifies the part in which the new patch will be loaded.
Range: Off, 1–16
•
Library
If the To parameter is set to “Library,” specifies the library number in which the new patch will be loaded.
Range: Off, 1–128
•
F-buttons
9.
Press [F5](Execute).
The patch will be imported into the specified part and library,
●
If you want to import into only one of these (part only or library only), turn the other setting Off.
F-button
Explanation
[F3](With Delete)
Deletes the samples used by the specified part or library patch (Delete Patch), and then load
the data
[F5](Execute) Loads the patch to the specified location.
MV-8800_e.book 64 ページ ２００６年１１月１０日 金曜日 午後１時４８分
To Next Page
Loading...
