List of available editing commands
M-199
MV-8800 Owner’s Manual
Editing a song / pattern
10
You can modify data such as volume and pan changes for automation in a selected region.
❍
Parameters to specify
•
Event
Specify the type of data that you want to edit.
•
Number
Specify the control change number that you want to edit, if you specified Control Change as the Event.
•
Note Range
Specify the range of note number that you want to edit, if you specified Poly Aftertouch as the Event.
•
Magnify
Use this to increase or decrease the upper limit or lower limit of the selected values.
With a setting of 100%, no change will occur. Use a setting of 101% or above to make the changes greater,
and a setting of 99% or below to make the changes smaller.
For example, a setting of 50% would halve the values and a setting of 200% would double the values. Negative
“-” settings will invert the upper and lower limit values.
•
Bias
Specifies the amount by which the data will be increased or decreased.
●
For details on all of the parameters and values of the Change Continuous Data command, refer to “CHANGE
CONTINUOUS DATA popup“ (Screen Guide; p. 68).
Modifying data in a selected region (Change Continuous Data)
MV-8800_e.book 199 ページ ２００６年１１月１０日 金曜日 午後１時４８分
To Next Page
Loading...
