Roland MV-8800

M-181
MV-8800 Owner’s Manual
Editing a song / pattern
10
Editing events individually
The method used in editing individual events differs depending on the type of track.
• MIDI track
Event list editing
• Audio track
Audio event parameter
• Pattern track
Pattern event parameter
The EVENT LIST screen lets you edit the individual MIDI messages recorded in your song / pattern. Each line
of this screen shows the location (measure - beat - tick), type of data, and value(s) of a single event.
1.
Access the SONG screen (Screen Guide; p. 8) or the PATTERN screen (Screen Guide; p. 91).
2.
Move the cursor to the MIDI track that you want to edit, making it the current track.
3. Press [F3](Event List).
The EVENT LIST screen (Screen Guide; p. 23) will appear.
4.
Use CURSOR [ ] [ ] or the VALUE dial to select the event (performance data) you want to
edit.
5.
Use CURSOR [ ] [ ] to move the cursor to the field for the parameter you want to edit.
The currently-edited event is enclosed by a frame.
6.
Turn the VALUE dial or use [DEC] [INC] to edit the value.
7.
Press [ENTER].
The edited value will be finalized.
Event list editing
● The EVENT LIST screen is available if the current track is a MIDI track.
● When you use CURSOR [ ] [ ] to change the current time, the note event located at that time will be
transmitted from the MIDI OUT connector.
● You can strike a pad to specify the value when editing the Note Number of a note or polyphonic aftertouch event,
or when editing the On Velocity.
● To specify the value of a parameter, you can use the VALUE dial or [DEC] [INC], or use the numeric keys to
input the value directly. After using the numeric keys to input a value, press [ENTER] to finalize the input.
MV-8800_e.book 181 ページ ２００６年１１月１０日 金曜日 午後１時４８分