Roland MV-8800

Editing events individually
M-182
MV-8800 Owner’s Manual
Here’s how to insert new performance data into the desired location within a MIDI track.
1.
Access the EVENT LIST screen as described in “Event list editing” (p. 181).
2.
Use CURSOR [ ] [ ] or the VALUE dial to move to the time location where you want to
insert a data event.
3.
Press [F1](Create).
The CREATE EVENT popup (Screen Guide; p. 25) will appear.
4.
Use CURSOR [ ] [ ] or the VALUE dial to select the type of performance data event that
will be inserted.
5.
Press [F5](Select).
The performance data will be inserted. The event will be inserted with default values; edit the values as
desired.
Inserting performance data (Create Event)
● For details on the types of performance data you can insert, refer to “Events Handled with MIDI Tracks” (p. 150).
● When you use CURSOR [ ] [ ] to change the current time, the note event located at that time will be
transmitted from the MIDI OUT connector.
● If you are not satisfied with the result of executing this command, press [UNDO/REDO] to return to the state
prior to execution (p. 166).
You can make the following settings in the EVENT LIST screen.
• Step Time (The unit by which the current time will move when you press STEP [ ] [ ])
• Track parameters of the current track
• Solo switch of the current track
1. Access the EVENT LIST screen as described in “Event list editing” (p. 181).
2. Press [MENU].
The MENU popup will appear.
You can make the following settings in the MENU popup.
• Step Time
Displays the STEP TIME popup (Screen Guide; p. 58). Specifies the unit by which the current time
will move when you press STEP [ ] [ ].
• Track Parameter
Displays the TRACK PARAMETER popup (for MIDI track).
• Solo On/Off
Turns solo on/off for the current track. When Solo is on, a “SOLO” indication appears at the right of
the track name.
MV-8800_e.book 182 ページ ２００６年１１月１０日 金曜日 午後１時４８分