Roland MV-8800

Playing a connected external MIDI sound module
M-296
MV-8800 Owner’s Manual
You can use the MV-8800’s sliders to send control change messages to a connected external device.
1.
Press [ASSIGNABLE SLIDER].
[ASSIGNABLE SLIDER] will light orange, indicating that sliders 1–8 are in Assignable Slider mode.
2.
Move sliders 1–8 to transmit control change messages. The control change messages will
be transmitted from MIDI OUT. Each slider transmits the following control change
message.
● Changing the control change messages that are transmitted
Here’s how you can assign different control change messages to the sliders.
1.
Press [SYSTEM].
The SYSTEM MENU screen (Screen Guide; p. 172) will appear.
2.
With the cursor located in the lower row of icons, press [F1](Slider). Alternatively, you can
select the SLIDER icon and press [ENTER].
The ASSIGNABLE SLIDER screen (Screen Guide; p. 182) will appear.
3.
Edit the Slider Assign parameters.
For each slider, specify the control change number that you want to assign. The message transmitted by the
slider will change according to the control change number you specify.
Using the sliders to control an external MIDI sound module (Assignable Sliders)
● When [ASSIGNABLE SLIDER] is lit orange, the sliders will transmit the assigned control change messages
regardless of the screen in which you are.
Slider
Control change
Number Message
1
7 Volume
2 10 Pan
3 91 Reverb Send level
4 93 Chorus Send Level
5 74 Cutoff Frequency
6 71 Resonance
7 73 Attack Time
8 72 Release Time
● You can change the control change numbers that are transmitted.
● The control change number table in the lower part of the screen will change according to the control change
numbers you assign.
MV-8800_e.book 296 ページ ２００６年１１月１０日 金曜日 午後１時４８分