Roland MV-8800

List of available editing commands
M-190
MV-8800 Owner’s Manual
● Copying data and inserting it at another location (Copy & Insert)
The Copy & Insert command inserts the copied performance data into another track or note number, and
moves the existing sequence data backward to make room.
❍ Parameters to specify
• To
Specify the new time to which the data will be copied.
• To Track
Specify the track to which the data will be copied. If you’re copying more than one track, you cannot copy to
other track (Displays “Multi Tracks Selected”).
• Shift All Notes / Shift All Tracks
If you check this item, all data following the insert location will be moved backward according to the playback
duration of the copied data.
● For details on all of the parameters and settings for Copy & Insert, refer to “COPY&INSERT popup” (Screen
Guide; p. 37).
● The To Track parameter is available if you accessed the COPY & INSERT popup from the SEQUENCE EDIT
screen.
● The Shift All Notes parameter is available if you accessed the COPY & INSERT popup from the PIANO ROLL
EDIT screen.
● The Shift All Tracks parameter is available if you accessed the COPY & INSERT popup from the SEQUENCE
EDIT screen.
Insertion point
Overlapping data
Shift All Notes/Shift All Tracks
will be moved backward.
(Off)
Insertion point
All data existing at the insertion time
will be moved backward.
Shift All Notes/Shift All Tracks
(On)
MV-8800_e.book 190 ページ ２００６年１１月１０日 金曜日 午後１時４８分