Roland MV-8800 - Page 256

Explanation of screens shown in the external display
M-256
MV-8800 Owner’s Manual
fig.transport-block3
● Launcher Block
fig.launcher-block1
Meas button
(Rewind/Forward)
These buttons move the current time location forward or backward in one-measure steps.
Stop button
To stop the sequencer.
Play button
To play the sequencer.
REC button
The RECORD PARAMETER popup will appear. Here you can make preparations for
recording data into the sequencer.
Step REC button
The STEP REC popup will appear. Starts the step recording.
REC Parameter
button
The RECORD PARAMETER popup will appear.
Song Position Bar
The entire length of this bar corresponds to the length of the current song/pattern, and the
scrollbar handle indicates the current time location. You can move the current time location by
dragging or clicking the scrollbar handle.
Explanation
BPM (Tempo)
This indicates the tempo at the current time location. If the tempo track is off, you can click
this value and change the tempo.
Tempo Track Switch
You can click this area to switch the Tempo Track On ( )/Off ( ).
Time Signature
Display the time signature of the current song/pattern.
Auto Punch button
This button switch the Auto Punch function On/Off.
Auto Punch
In/Out
This area indicates the auto punch-in time (at left) and auto punch-out time (at right). You
can click a numerical field and change the time.
Loop button
This button switch the Loop function On/Off.
Loop Start/End
This area indicates the loop-start time (at left) and loop-end time (at right). You can click a
numerical field and change the time.
Metronome Mode
Specifies when the metronome signal will be output.
Loop Quick Set
button
This button makes the playback loop from the beginning of the current beat for the length
specified by the Quick Loop Length setting.
Quick Loop Length
This indicates the loop length that will be used when you press the Loop Quick Set button.
You can click this to see a list of the available loop lengths.
Explanation
Sampling button
The SAMPLING popup will appear. Here you can make settings and execute sampling.
Import button
The IMPORT popup will appear. Here you can import data from the hard disk or a CD.
Instruments button
The INSTRUMENTS popup will appear. Here you can edit or make settings for instruments.
Audio Phrases
button
The AUDIO PHRASES popup will appear. Here you can edit or make settings for audio
phrases.
Quick Edit button
Here you can edit the audio phrases or the partials of the current track.
Track Mute button
The TRACK MUTE popup will appear. Here you can switch the Mute and Solo settings for
each track.
Pad Banks button The PAD BANKS popup will appear. Here you can switch the pad bank of the velocity pads.
Pad Bank
Number/Name
Display the current pad bank and pad name. If the tempo track is off, you can click this value
and change the current pad bank.
Explanation
MV-8800_e.book 256 ページ ２００６年１１月１０日 金曜日 午後１時４８分