Roland MV-8800

Playing the MV-8800 from an external MIDI device
M-299
MV-8800 Owner’s Manual
Using MIDI devices
19
As shown below, the performance data flow differs depending on the Multi Timbre Sampler Mode setting in the MIDI
screen.
● When Off (normal)
fig.multitimbre-off
Performance data received at MIDI IN or from the velocity pads is sent to MIDI OUT and/or plays the
MV-8800’s instruments according to the Output Assign parameter and Output Assign MIDI parameter of
the current track.
● When On
The MV-8800 will operate in the following way.
fig.multitimbre-on
• Operate as a multi-timbral sound module
Performance data received at MIDI IN is sent to the sampler section (instruments, audio phrases, and
MFX). If the MIDI screen’s (Screen Guide; p. 177) Audio Phrase Rx Channel parameter or MFX RxChannel
parameter is Off, each instrument will receive performance data on the MIDI channel that matches its part
number.
• Performance data from the velocity pads cannot be sent to the internal sound generator.
• Performance data cannot be recorded on the MV-8800’s internal sequencer.
• Multi Timbre Sampler Mode is available only while the following screens are displayed.
- SONG screen
- PATTERN screen
- INSTRUMENTS screen (performance data from the velocity pads is not transmitted)
- EFFECTS screen
- MIXER screen
Performance Data Flow in Multi Timbre Sampler Mode
Limitations when Multi Timbre Sampler Mode is On
Velocity Pads
MIDI IN
MIDI OUT A/B
Sequencer Instruments
(1–16)
MIDI Ch. 16
MIDI Ch. 1
MV-8800
:
Velocity Pads
MIDI IN
MIDI OUT A/B
Sequencer Instruments
MV-8800
MV-8800_e.book 299 ページ ２００６年１１月１０日 金曜日 午後１時４８分