Synchronizing the MV-8800 with a connected external sequencer
M-306
MV-8800 Owner’s Manual
●
Receive and synchronize to MTC
MTC messages from an externally connected sequencer or recorder (“master device”) can be received by the
MV-8800, causing the MV-8800 to operate in synchronization as a slave device.
The example given below is a setup in which a recorder is the master device, and the MV-8800 receives MTC
messages at its MIDI IN.
fig.MV-clock-2400CD.e
❍
Song mode
1.
Press [SONG].
The SONG screen (Screen Guide; p. 8) will appear.
2.
Press [F1](Song Menu).
The SONG MENU screen (Screen Guide; p. 78) will appear.
3.
With the cursor located in the upper row of icons, press [F2](Sync). Alternatively, select the
SYNC icon and press [ENTER].
The SYNC screen (Screen Guide; p. 81) will appear.
fig.sync-screen.eps
●
When the MV-8800 is operating as a synchronization slave, the synchronization signals can be received
through either the MV-8800’s MIDI IN connector or the MIDI IN connector of the DIF-AT24. However, you must
set the Sync Mode (Screen Guide; p. 81) to specify the connector through which the synchronization signals
are to be received.
Recorder
MV-8800
MIDI Cable
MTC/MMC
MIDI OUTMIDI IN
MV-8800_e.book 306 ページ ２００６年１１月１０日 金曜日 午後１時４８分
To Next Page
Loading...
