Roland MV-8800

Synchronizing the MV-8800 with a connected external sequencer
M-308
MV-8800 Owner’s Manual
Since MMC commands are exclusive messages, the MV-8800 will not follow them unless its Device ID matches.
Use the following procedure to set the Device ID.
1. Press [SYSTEM].
The SYSTEM MENU screen (Screen Guide; p. 172) will appear.
2. With the cursor located in the upper row of icons, press [F3](MIDI). Alternatively,
select the MIDI icon and press [ENTER].
The MIDI screen (Screen Guide; p. 177) will appear.
3. Set the Device ID.
Set this value to match the Device ID setting of the MMC messages that are being sent to the
MV-8800.
If the sequencer does not operate when MMC is received
● If the incoming messages have a device ID of “7F” (Broadcast), the messages will be received regardless of
the Device ID setting.
MV-8800_e.book 308 ページ ２００６年１１月１０日 金曜日 午後１時４８分