Roland SH-4d - BPM Looper

MFX Parameters
143
BPM Looper
Loops a short portion of the input sound.
This can automatically turn the loop on/off in synchronization with the rhythm.
Parameter
Value
Explanation
Length
230–23 (not
straight)
Specifies the length of the loop.
Rate Sync
OFF, ON
If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System)(P.76)
Rate
0.05–10.00 [Hz]
Cycle at which the loop automatically turns on/off
Rate Note
Note(P.167)
Timing
1–8
Specifies the timing within the cycle at which the loop automatically starts (which step of the
eight timing divisions at which the sound is heard).
Lenth
1–8
Specifies the length at which the loop automatically ends within the cycle (the number of times
that the 1/8-length of sound is heard).
Loop
Mode
OFF, AUTO, ON
If this is AUTO, the loop automatically turns on/off in synchronization with the rhythm.
* If the effect is recalled with this ON, this parameter must first be set to something other
than ON in order to make the loop operate.
Level
0–127
Output Level