Roland SH-4d - Reverse Dly (Reverse Delay)

MFX Parameters
138
Parameter
Value
Explanation
Dly1 Fbk
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the
effect.
Negative (-) settings will invert the phase.
HF Damp
200, 250, 315, 400, 500, 630, 800, 1000, 1250,
1600, 2000, 2500, 3150, 4000, 5000, 6300,
8000, BYPASS [Hz]
Adjusts the frequency above which sound fed back to the effect is
filtered out. If you don’t want to filter out any high frequencies, set
this parameter to BYPASS.
Dly1 Pan
L64–63R
Stereo location of Delays 1–4
Dly2 Pan
L64–63R
Dly3 Pan
L64–63R
Dly4 Pan
L64–63R
Dly1 Lv
0–127
Volume of each delay
Dly2 Lv
0–127
Dly3 Lv
0–127
Dly4 Lv
0–127
Low Gain
-15–+15 [dB]
Amount of boost/cut for the low-frequency range
High Gain
-15–+15 [dB]
Amount of boost/cut for the high-frequency range
Balance
D100: 0W–D0: 100W
Volume balance between the direct sound (D) and the effect sound
(W)
Level
0–127
Output Level
Reverse Dly (Reverse Delay)
This is a reverse delay that adds a reversed and delayed sound to the input sound.
A tap delay is connected immediately after the reverse delay.
Parameter
Value
Explanation
Threshold
0–127
Volume at which the reverse delay will begin to be applied
RDly Sync
OFF, ON
If this is ON, the rate synchronizes with the tempo of the
rhythm.
Tempo (Pattern)
Tempo (System)(P.76)
RD. Time
1–1300
Delay time from when sound is input into the reverse delay
until the delay sound is heard
RD.Time
Nt
Note(P.167)
RDly Fbk
-98–+98 [%]
Proportion of the delay sound that is to be returned to the
input of the reverse delay negative (-) values invert the
phase)
RDly HF
200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600,
2000, 2500, 3150, 4000, 5000, 6300, 8000, BYPASS
[Hz]
Frequency at which the high-frequency content of the
reverse-delayed sound will be cut (BYPASS: no cut)
RDly Pan
L64–63R
Panning of the reverse delay sound
RDly Level
0–127
Volume of the reverse delay sound