Roland SH-4d - EP -> Tremolo (EP Amp Simulator -> Tremolo)

MFX Parameters
158
Parameter
Value
Explanation
Negative (-) settings will invert the phase.
Dly HF
200, 250, 315, 400, 500, 630, 800, 1000,
1250, 1600, 2000, 2500, 3150, 4000, 5000,
6300, 8000, BYPASS [Hz]
Frequency at which the high-frequency portion of the delay sound
will be cut (BYPASS: no cut)
Dly Bal
D100: 0W–D0: 100W
Adjusts the volume balance between the sound that is sent through
the delay (W) and the sound that is not sent through the delay (D).
Level
0–127
Output Level
EP -> Tremolo (EP Amp Simulator -> Tremolo)
Parameter
Value
Explanation
Type
Type of amp
OLDCASE
A standard electric piano sound of the early 70s
NEWCASE
A standard electric piano sound of the late 70s and early 80s
WURLY
A standard electric piano sound of the 60s
Bass
-50–+50
Amount of low-frequency boost/cut
Treble
-50–+50
Amount of high-frequency boost/cut
Tremolo Sw
OFF, ON
Tremolo on/off
Tremolo Sync
OFF, ON
If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System)(P.76)
T. Speed
0.05–10.00 [Hz]
Rate of the tremolo effect
T.Spd Nt
Note(P.167)
Trm Depth
0–127
Depth of the tremolo effect
Trm Duty
-10–+10
Adjusts the duty cycle of the LFO waveform used to apply tremolo.
Sp Type
LINE, OLD, NEW, WURLY, TWIN
Type of speaker
If LINE is selected, the sound will not be sent through the speaker simulation.
OD Switch
OFF, ON
Overdrive on/off
OD Gain
0–127
Overdrive input level
OD Drive
0–127
Degree of distortion
Also changes the volume.
Level
0–127
Output Level