Roland SH-4d - PATTERN DELAY; Delay Parameters; Delay

PATTERN DELAY
171
PATTERN DELAY
Parameter
Value
Explanation
Type
Ø “Delay Parameters(P.171)”
Switch
OFF, ON
Switches the delay on/off.
Delay parameters
Configure the parameters of the selected delay type.
The available parameters differ depending on the type of delay you selected in Type.
Ø “Delay Parameters(P.171)”
Level
0–127
Specifies the output level of the sound with delay applied.
Rev Send
0–127
Specifies the send level to the reverb.
Delay Parameters
OFF
Turns the effect off.
Delay
This is a stereo delay.
Parameter
Value
Explanation
Dly Sync
OFF, ON
If this is ON, the delay synchronizes with the tempo.
Dly Msec
1–1300
Adjusts the delay time from the direct sound until the delay sound is heard.
Dly Note
Note
Feedback
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the effect. Negative (-) settings
will invert the phase.
HF Damp
200–8000 [Hz],
BYPASS (*1)
Adjusts the frequency above which sound fed back to the effect is filtered out. If you don’t want
to filter out any high frequencies, set this parameter to BYPASS.
T-Ctrl Dly (Time Control Delay)
This is a delay in which the delay time can be varied smoothly.
Parameter
Value
Explanation
Dly Sync
OFF, ON
If this is ON, the delay synchronizes with the tempo.
Dly Msec
1–1300
Adjusts the delay time from the direct sound until the delay sound is heard.
Dly Note
Note
Acceleration
0–15
When you change the delay time, this specifies the time over which the current delay time
changes to the specified delay time.
This affects the speed of pitch change as well as the delay time.
Feedback
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the effect. Negative (-) settings
will invert the phase.
HF Damp
200–8000 [Hz],
BYPASS (*1)
Adjusts the frequency above which sound fed back to the effect is filtered out. If you don’t
want to filter out any high frequencies, set this parameter to BYPASS.
Delay Ó Trem (delay Ó tremolo)
Tremolo is applied to the delay sound.
Parameter
Value
Explanation
Input
MONAURAL
The input is mono-mixed.
STEREO
The sound is input in stereo.
Dly Sync
OFF, ON
If this is ON, the delay synchronizes with the tempo.
Dly Msec
1–1300
Adjusts the delay time from the direct sound until the delay sound is heard.
Dly Note
Note
Feedback
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the effect. Negative (-)
settings will invert the phase.
HF Damp
200–8000 [Hz],
BYPASS (*1)
Adjusts the frequency above which sound fed back to the effect is filtered out. If you don’t
want to filter out any high frequencies, set this parameter to BYPASS.
Trm Switch
OFF, ON
Switches the tremolo effect on/off