Roland SH-4d - Main Menu (MENU); System Settings (SYSTEM SETTINGS)

Main Menu (MENU)
76
Main Menu (MENU)
1. Hold down the [SHIFT] button and press the [16] button.
The MENU screen appears.
2. Turn the [1] and [2] knobs to select a menu item, and press the [ENTER] button.
Item
Explanation
SYSTEM SETTINGS
Configures the system settings.
SYSTEM EQ/COMP
Configures the equalizer and compressor settings for the system.
VISUAL ARPEGGIO
Opens the VISUAL ARPEGGIO menu.
FACTORY RESET
Performs a factory reset.
INFORMATION
Shows the version information for the system.
System Settings (SYSTEM SETTINGS)
Here are the system settings that you can configure.
GENERAL
Parameter
Value
Explanation
System Tune
415.3–
466.2
Adjusts the overall tuning.
The value shown is the frequency of the A4 key (middle A).
Sys Key Shift
-24–+24
Shifts the overall pitch range in semitone steps.
USB In Lev
0–127
Adjusts the level of audio input from the USB port.
USB Out Lev
0–127
Adjusts the level of audio output from the USB port.
USB In to
MFX
OFF, ON
Sets whether to mix the sound of this unit with the audio input signal from the USB port and input
the result to the pattern effect (ON), or to mix only the MAIN OUT/PHONES OUT signals from this
unit without the audio input signal from the USB port (OFF).
* When this is ON, the USB input from this unit is looped back to the USB output, even when the
pattern effect is off. Make sure before turning this ON that the signal is not looped within the device
you’ve connected to this unit.
Auto Off
OFF, 30min,
240min
Specifies whether the unit will turn off automatically after a certain time has elapsed. If you don’t
want the unit to turn off automatically, choose “OFF” setting.
The Auto Off setting is disabled (the power does not turn off automatically) when the unit is
connected via USB.