Roland SH-4d - Page 77

Main Menu (MENU)
77
Parameter
Value
Explanation
LCD
Contrast
1–10
Adjusts the contrast of the display.
Startup
Pattern
01-01–08-
16
Specifies the pattern that is selected at start-up.
OSC MODEL
Lock
OFF, ON
If this is “ON”, a dialog box is displayed that confirms the change in oscillator modes when you turn
the model knob.
TEMPO/SYNC
Parameter
Value
Explanation
Tempo
20.00–300.00
Specifies the system tempo.
Tempo Src
PATTERN,
SYSTEM
When you switch patterns, this setting specifies whether to use the system tempo (SYSTEM) or
the tempo stored in the pattern (PATTERN).
Sync
Mode
AUTO, INT, MIDI,
USB
Sets which synchronization signal is used by this unit.
If a plug is connected to the EXT CLK IN jack, this unit always operates in sync with the signals
received from the EXT CLK IN jack, regardless of the Sync Mode setting on this unit.
Ø “EXT CLK IN jack(P.12)”
Sync Out
OFF, MIDI, USB,
MIDI/USB
Specifies the connector from which MIDI clock messages etc. are output.
MIDI
Parameter
Value
Explanation
Ctrl Ch
1–16, OFF
Specifies the MIDI receive channel on which MIDI messages (program change and bank select) from
an external MIDI device can be received to switch programs.
If you don’t want programs to be switched from a connected MIDI device, turn this “OFF”.
Part 1 Ch
1–16
Specifies the MIDI receive channel for part 1.
Part 2 Ch
1–16
Specifies the MIDI receive channel for part 2.
Part 3 Ch
1–16
Specifies the MIDI receive channel for part 3.
Part 4 Ch
1–16
Specifies the MIDI receive channel for part 4.
Part R Ch
1–16
Specifies the MIDI receiving channel for part R.
Soft Thru
OFF, ON
If this is ON, MIDI messages that are input from the MIDI IN connector are re-transmitted without
change from the MIDI OUT connector.
USB-MIDI
Thru
OFF, ON
Specifies whether MIDI messages received at the USB or MIDI IN port are transmitted without
change from the MIDI OUT connector and USB port (ON) or not (OFF).
Remote Kbd
OFF, MIDI
IN, USB
Sets which connector is used for input when you use an external MIDI keyboard instead of the
keyboard of the SH-4d.
Normally you will leave this “OFF”.
Set the transmit channel of your external MIDI keyboard to the Ctrl Ch of this unit.
Ø “System Settings (SYSTEM SETTINGS)(P.76)”
Local Sw
OFF, ON
Connects (ON) or disconnects (OFF) the keyboard from the internal sound generator.
MIDI Tx
Parameter
Value
Explanation
Tx PC
OFF, ON
Specifies whether program change messages will be transmitted (ON) or not be transmitted (OFF).
Tx Bank
OFF, ON
Specifies whether bank select messages will be transmitted (ON) or not be transmitted (OFF).
MIDI Rx
Parameter
Value
Explanation
Rx PC
OFF, ON
Specifies whether program change messages will be received (ON) or not be received (OFF).
Rx Bank
OFF, ON
Specifies whether bank select messages will be received (ON) or not be received (OFF).