Roland SH-4d - Pshifter (2 Voice Pitch Shifter)

MFX Parameters
147
2V PShifter (2 Voice Pitch Shifter)
Shifts the pitch of the original sound.
This 2-voice pitch shifter has two pitch shifters, and can add two pitch shifted sounds to the original sound.
Parameter
Value
Explanation
P1Coarse
-24–+12 [sem]
Adjusts the pitch of Pitch Shift 1 in semitone steps.
P1 Fine
-100–+100
Adjusts the pitch of Pitch Shift Pitch 1 in 2-cent steps.
P1 Dly Sync
OFF, ON
If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System)(P.76)
P1D.Time
1–1300
Adjusts the delay time from the direct sound until the Pitch Shift 1 sound is heard.
P1DRate Nt
Note(P.167)
P1 Feedback
-98–+98 [%]
Adjusts the proportion of the pitch shifted sound that is fed back into the effect.
Negative (-) settings will invert the phase.
P1 Pan
L64–63R
Stereo location of the Pitch Shift 1 sound
P1 Level
0–127
Volume of the Pitch Shift 1 sound
P2Coarse
-24–+12 [sem]
Settings of the Pitch Shift 2 sound.
The parameters are the same as for the Pitch Shift 1 sound.
P2 Fine
-100–+100
P2 Dly Sync
OFF, ON
P2D.Time
1–1300
P2DRate Nt
Note
P2 Feedback
-98–+98 [%]
P2 Pan
L64–63R
P2 Level
0–127
Low Gain
-15–+15 [dB]
Amount of boost/cut for the low-frequency range
High Gain
-15–+15 [dB]
Amount of boost/cut for the high-frequency range
Balance
D100: 0W–D0: 100W
Volume balance between the direct sound (D) and the pitch shifted sound (W)
Level
0–127
Output Level