MFX Parameters
154
Adjusts the delay time from the direct sound until the chorus sound is heard.
Cho Bal
Adjusts the volume balance between the sound that is sent through the chorus (W) and the
sound that is not sent through the chorus (D).
Gt -> Flanger (Guitar Amp Simulator -> Flanger)
Turns the amp switch on/off.
ATyp
This models the sound of the Roland JC-120.
This models a Fender Twin Reverb.
MATCH DRIVE
This models the sound input to left input on a Matchless D/C-30.
A simulation of the latest tube amp widely used in styles from blues and rock.
BG LEAD
This models the lead sound of the MESA/ Boogie combo amp.
The sound of a tube amp typical of the late ’70s to ’80s.
MS1959I
This models the sound input to Input I on a Marshall 1959.
This is a trebly sound suited to hard rock.
This models the sound input to Input II on a Marshall 1959.
MS1959I+II
The sound of connecting inputs I and II of the guitar amp in parallel, creating a sound with
a stronger low end than I.
This models a Soldano SLO-100. This is the typical sound of the eighties.
This models the lead channel of a Peavey EVH 5150.
This is distortion sound that is ideal for performances of heavy riffs.
OD-1
This models the sound of the BOSS OD-1.
This produces sweet, mild distortion.
This is the high-gain overdrive sound of the BOSS OD-2.
This gives a basic, traditional distortion sound.
A fuzz sound with rich harmonic content.
Volume and amount of distortion of the amp
Volume of the entire pre-amp
Amount of pre-amp distortion
To Next Page
Loading...
Need help?
General
Weight and Dimensions
