Roland SH-4d - DRAWING OSC MODEL DRAWING

Creating a Tone
36
DRAWING
Use the [1] and [2] knobs to set the waveform shape.
When you press the [ENTER] button, the cursor moves automatically, so you can draw the waveform by turning only the [2] knob.
Parameter
Controllers
Value
Explanation
Wave Step 1–
32
[2] knob, [
ä
] [
å
] buttons (on the top
screen only)
-72–
+72
Sets the value for each step in the waveform data.
Coarse Tune
PITCH
-24–
+24
Specifies the pitch in semitone steps (maximum ±2 octaves).
Wave Edge
TIMBRE
0–127
Sets how smoothly the steps are connected when playing back
a waveform.
Smaller values produce smoother transitions between steps.
Step 1–8
[OSC 1] slider
-72–
+72
Sets the values for steps 1–8 in the waveform data.
Step 9–16
[OSC 2] slider
-72–
+72
Sets the values for steps 9–16 in the waveform data.
Step 17–24
[OSC 3] slider
-72–
+72
Sets the values for steps 17–24 in the waveform data.
Step 25–32
[OSC 4] slider
-72–
+72
Sets the value for steps 25–32 in the waveform data.
Step 1–8 Slope
[OSC 1] button + [OSC 1] slider
-18–
+18
Sets the slope of the straight lines that connect steps 1 through
8 in the waveform data.
Step 9–16
Slope
[OSC 2] button + [OSC 2] slider
-18–
+18
Sets the slope of the straight lines that connect steps 9 through
16 in the waveform data.
Step 17–24
Slope
[OSC 3] button + [OSC 3] slider
-18–
+18
Sets the slope of the straight lines that connect steps 17
through 24 in the waveform data.
Step 25–32
Slope
[OSC 4] button + [OSC 4] slider
-18–
+18
Sets the slope of the straight lines that connect steps 25
through 32 in the waveform data.