Creating a Tone
26
Oscillator Model
A virtual analog oscillator with four oscillators, featuring selectable waveforms that can be mixed.
A virtual analog oscillator with three oscillators and a secondary LFO.
Two synchronizable virtual analog oscillators with a pitch envelope.
An oscillator that recreates the famed SH-101 vintage mono synth.
An oscillator that recreates the widely used JUNO-106 vintage poly synth.
An oscillator that recreates a two-operator FM synth.
An oscillator that features two oscillators and a ring modulator.
A wavetable oscillator that lets you modulate the wave position.
A chord oscillator that lets you freely control the chord shape.
An oscillator that lets you instantly play the waveforms you draw on the screen.
A PCM oscillator that lets you mix and play four waveforms.
For some oscillator models, you can press the OSC section [1]–[4] buttons while holding down the [SHIFT] button to show the
OSC SETTINGS screen.
This lets you configure the parameters that aren’t assigned to a controller.
SH-4d
Turn the [1] knob or press the [OSC 1]–[OSC 4] buttons to select an oscillator, and use the [2] knob to select the oscillator
waveform.
Use the [OSC 1]–[OSC 4] sliders to set the volume for each oscillator.
Osc 1–4
Waveform
top screen only)
To Next Page
