Roland SH-4d - MFX Common Parameters

MFX Parameters
89
Combination(P.148)
OD -> Chorus (Overdrive -> Chorus)(P.148)
OD -> Flanger (Overdrive -> Flanger)(P.148)
OD -> Delay (Overdrive -> Delay)(P.149)
DS -> Chorus (Distortion -> Chorus)(P.150)
DS -> Flanger (Distortion -> Flanger)(P.150)
DS -> Delay (Distortion -> Delay)(P.151)
OD/DS -> T. Wah (Overdrive/Distortion -> Touch Wah)(P.151)
OD/DS -> A. Wah (Overdrive/Distortion -> Auto Wah)(P.152)
Gt -> Chorus (Guitar Amp Simulator -> Chorus)(P.153)
Gt -> Flanger (Guitar Amp Simulator -> Flanger)(P.154)
Gt -> Phaser (Guitar Amp Simulator -> Phaser)(P.155)
Gt -> Delay (Guitar Amp Simulator -> Delay)(P.156)
EP -> Tremolo (EP Amp Simulator -> Tremolo)(P.158)
EP -> Chorus (EP Amp Simulator -> Chorus)(P.159)
EP -> Flanger (EP Amp Simulator -> Flanger)(P.159)
EP -> Phaser (EP Amp Simulator -> Phaser)(P.160)
EP -> Delay (EP Amp Simulator -> Delay)(P.161)
Enhncr -> Cho (Enhancer -> Chorus)(P.162)
Enhncr -> Fl (Enhancer -> Flanger)(P.162)
Enhncr -> Dly (Enhancer -> Delay)(P.163)
Chorus -> Dly (Chorus -> Delay)(P.163)
Flanger -> Dly (Flanger -> Delay)(P.164)
Chorus -> Fl (Chorus -> Flanger)(P.165)
JD-Multi(P.165)
MFX Common Parameters
Parameter
Value
Explanation
Categ
Selects the MFX category.
Type
Selects the MFX type.
Switch
OFF, ON
Switches the MFX on/off.
MFX parameters
Depends on the MFX type.
For details, refer to each MFX parameter.
Cho Send
0–127
Sets the amount of chorus.
If you don’t want to add the chorus effect, set it to 0.
Rev Send
0–127
Sets the amount of reverb.
If you don’t want to add the reverb effect, set it to 0.
●
When sending audio signals with the rhythm part from the MFX to the pattern chorus/reverb, raise the
Reverb/Chorus/Delay Send level of the rhythm part to set on the MIXER screen.
Ø “Adjusting the Volume Balance and Effect Sends(P.21)”
● For the rhythm part, the signal sent from the MFX to the pattern chorus/reverb is routed separately from the effect send
for each rhythm instrument.