Roland SH-4d - Gate

MFX Parameters
130
Gate
Cuts the reverb’s delay according to the volume of the sound sent into the effect.
Use this when you want to create an artificial-sounding decrease in the reverb’s decay.
Parameter
Value
Explanation
Threshold
0–127
Volume level at which the gate begins to close
Mode
GATE, DUCK
Type of gate
GATE: The gate will close when the volume of the original sound decreases, cutting the original
sound.
DUCK (Duking): The gate will close when the volume of the original sound increases, cutting the
original sound.
Attack
0–127
Adjusts the time it takes for the gate to fully open after being triggered.
Hold
0–127
Adjusts the time it takes for the gate to start closing after the source sound falls beneath the
Threshold.
Release
0–127
Adjusts the time it takes the gate to fully close after the hold time.
Balance
D100: 0W–D0:
100W
Volume balance between the direct sound (D) and the effect sound (W)
Level
0–127
Output Level