Roland SH-4d - SYNC OSC MODEL SYNC

Creating a Tone
30
Parameter
Controllers
Value
Explanation
LFO 2 Phase
Pos
–
Sets the LFO 2 start phase value when Key Trigger is “ON”.
0
1 cycle
1
1/4 cycle
2
1/2 cycle
3
3/4 cycle
SYNC
Use the [2] knob to set the waveform.
Parameter
Controllers
Value
Explanation
Coarse
Tune
PITCH
-24–+24
Specifies the pitch in semitone steps (maximum ±2 octaves).
Fine Tune
SHIFT+PITCH
-50–+50
Specifies the pitch in cents (maximum ±50 cents).
PWM Depth
TIMBRE
0–63
Sets how much the LFO is applied (depth) to the PW (pulse width).
The pulse width is modulated according to the LFO settings.
Pulse Width
SHIFT+TIMBRE
0–63
This effect changes the duty ratio of the pulse width to alter the
waveform.
You can use this effect with other waveforms besides SQR (square
wave).
* A value of zero results in a 50:50% duty ratio.
Detune
[OSC 1] slider
0–48
Sets the pitch of the synchronized oscillator in semitones.
PEnv Attack
[OSC 2] slider
0–1023
Sets the attack time of the pitch envelope.
PEnv Decay
[OSC 3] slider
0–1023
Sets the decay time of the pitch envelope.
PEnv Depth
[OSC 4] slider
0–100
Sets the intensity of the pitch envelope.
Larger values produce a greater change with the pitch envelope.
Mono/Poly
[OSC 1] and [OSC 2]
buttons
MONO,
POLY
Sets whether the tones play in polyphonic (POLY) or monophonic
(MONO) mode.
Sync
[OSC 4] button
OFF, ON
Turns oscillator sync on/off.