Roland SH-4d - JUNO-106 OSC MODEL JUNO-106

Creating a Tone
32
JUNO-106
Parameter
Controllers
Value
Explanation
Coarse Tune
PITCH
-24–
+24
Specifies the pitch in semitone steps (maximum ±2 octaves).
Fine Tune
SHIFT+PITCH
-50–
+50
Specifies the pitch in cents (maximum ±50 cents).
Pulse Width
TIMBRE
0–63
Changes the duty ratio of the pulse width to alter the waveform.
* A value of zero results in a 50:50% duty ratio.
LFO Pitch
Depth
[OSC 1] slider
0–100
Sets the depth of the LFO when it is applied to the pitch.
PWM Depth
[OSC 2] slider
0–63
Sets how much the LFO is applied (depth) to the PW (pulse width) of the square
wave.
The pulse width is modulated according to the LFO settings.
Sub Osc Level
[OSC 3] slider
0–127
Sets the sub-oscillator volume.
Noise Level
[OSC 4] slider
0–127
Sets the noise generator volume.
Square Switch
[OSC 2]
button
OFF, ON
Turns the square wave on/off.
Saw Switch
[OSC 3]
button
OFF, ON
Turns the sawtooth wave on/off.