Roland SH-4d - Modulation Type; Ring Mod (Ring modulator)

MFX Parameters
114
Modulation Type
Ring Mod (Ring modulator)
This is an effect that applies amplitude modulation (AM) to the input signal, producing bell-like sounds.
You can also change the modulation frequency in response to changes in the volume of the sound sent into the effect.
Parameter
Value
Explanation
Frequency
0–127
Adjusts the frequency at which modulation is applied.
Sens
0–127
Adjusts the amount of frequency modulation applied.
Polarity
UP, DOWN
Determines whether the frequency modulation moves towards higher frequencies or lower
frequencies.
UP: The filter will change toward a higher frequency.
DOWN: The filter will change toward a lower frequency.
Low Gain
-15–+15 [dB]
Amount of boost/cut for the low-frequency range
High Gain
-15–+15 [dB]
Amount of boost/cut for the high-frequency range
Balance
D100: 0W–D0:
100W
Volume balance between the direct sound (D) and the effect sound (W)
Level
0–127
Output Level