Roland SH-4d - EP -> Phaser (EP Amp Simulator -> Phaser)

MFX Parameters
160
Parameter
Value
Explanation
NEWCASE
A standard electric piano sound of the late 70s and early 80s
Bass
-50–+50
Amount of low-frequency boost/cut
Treble
-50–+50
Amount of high-frequency boost/cut
Flg Switch
OFF, ON
Flanger on/off
Flg PreDly
0.0–100 [ms]
Adjusts the delay time from the direct sound until the flanger sound is heard.
Flg Sync
OFF, ON
If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System)(P.76)
F. Rate
0.05–10.00 [Hz]
Frequency of modulation
F.Rate Nt
Note(P.167)
Flg Depth
0–127
Depth of modulation
Flg Fbk
-98–+98 [%]
Adjusts the proportion of the flanger sound that is fed back into the effect. Negative (-)
settings will invert the phase.
Flg Bal
D100: 0W–D0: 100W
Adjusts the volume balance between the sound that is sent through the flanger (W) and
the sound that is not sent through the flanger (D).
Sp Type
LINE, OLD, NEW,
WURLY, TWIN
Type of speaker
If LINE is selected, the sound will not be sent through the speaker simulation.
OD Switch
OFF, ON
Overdrive on/off
OD Gain
0–127
Overdrive input level
OD Drive
0–127
Degree of distortion
Also changes the volume.
Level
0–127
Output Level
EP -> Phaser (EP Amp Simulator -> Phaser)
Parameter
Value
Explanation
Type
Type of amp
OLDCASE
A standard electric piano sound of the early 70s
NEWCASE
A standard electric piano sound of the late 70s and early 80s
Bass
-50–+50
Amount of low-frequency boost/cut
Treble
-50–+50
Amount of high-frequency boost/cut
Phs Switch
OFF, ON
Phaser on/off
Phs Sync
OFF, ON
If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System)(P.76)
P. Rate
0.05–10.00 [Hz]
Frequency of modulation
P.Rate Nt
Note(P.167)
Phs Manual
0–127
Adjusts the basic frequency from which the sound will be modulated.
Phs Depth
0–127
Depth of modulation
Phs Reso
0–127
Amount of feedback
Phs Mix
0–127
Level of the phase-shifted sound
Sp Type
LINE, OLD, NEW, WURLY, TWIN
Type of speaker
If LINE is selected, the sound will not be sent through the speaker simulation.
OD Switch
OFF, ON
Overdrive on/off
OD Gain
0–127
Overdrive input level
OD Drive
0–127
Degree of distortion
Also changes the volume.
Level
0–127
Output Level