Roland SH-4d - Flanger -> Dly (Flanger -> Delay)

MFX Parameters
164
Parameter
Value
Explanation
Tempo (System)(P.76)
C. Rate
0.05–10.00 [Hz]
Frequency of modulation
C.Rate Nt
Note(P.167)
Cho Depth
0–127
Depth of modulation
Cho Bal
D100: 0W–D0: 100W
Volume balance between the direct sound (D) and the chorus
sound (W)
Delay
Sync
OFF, ON
If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System)(P.76)
D. Time
1–2600
Delay time from when the original sound is heard to when the
delay sound is heard
D.Time Nt
Note(P.167)
Delay Fbk
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the
effect.
Negative (-) settings will invert the phase.
Dly HF
200, 250, 315, 400, 500, 630, 800, 1000, 1250,
1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000,
BYPASS [Hz]
Adjusts the frequency above which sound fed back to the effect
will be cut. If you do not want to cut the high frequencies, set this
parameter to BYPASS.
Dly Bal
D100: 0W–D0: 100W
Adjusts the volume balance between the sound that is sent
through the delay (W) and the sound that is not sent through the
delay (D).
Level
0–127
Output Level
Flanger -> Dly (Flanger -> Delay)
Parameter
Value
Explanation
Flg PreDly
0.0–100 [ms]
Adjusts the delay time from the direct sound until the flanger
sound is heard.
Flg Sync
OFF, ON
If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System)(P.76)
F. Rate
0.05–10.00 [Hz]
Frequency of modulation
F.Rate Nt
Note(P.167)
Flg Depth
0–127
Depth of modulation
Flg Fbk
-98–+98 [%]
Adjusts the proportion of the flanger sound that is fed back into
the effect.
Negative (-) settings will invert the phase.
Flg Bal
D100: 0W–D0: 100W
Volume balance between the direct sound (D) and the flanger
sound (W)
Delay
Sync
OFF, ON
If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System)(P.76)
D. Time
1–2600
Delay time from when the original sound is heard to when the
delay sound is heard
D.Time Nt
Note(P.167)
Delay Fbk
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the
effect.
Negative (-) settings will invert the phase.
Dly HF
200, 250, 315, 400, 500, 630, 800, 1000, 1250,
1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000,
BYPASS [Hz]
Adjusts the frequency above which sound fed back to the effect
will be cut. If you do not want to cut the high frequencies, set this
parameter to BYPASS.