Roland SH-4d - Copying and Pasting the Content of Patterns

Copying and Pasting the Content of Patterns
69
Copying and Pasting the Content of Patterns
You can copy and paste the data in a pattern to a different pattern, part or step.
Copying the Data
1. Hold down the [SHIFT] button and press the [13] button.
The COPY screen appears.
2. Press the [ç] [æ ] buttons or the [1] knob to select what to copy (the copy source).
Copy source
Explanation
PATTERN
Copies the entire contents of the pattern.
The tone numbers that are loaded into each part of the pattern are also copied/pasted.
The existing content of tones that are not saved are lost when you paste the new data.
PART
Copies the content of the current part from the pattern.
Tone numbers are not copied/pasted.
STEP
Copies the content of one step from the step sequencer of the current part.
Use the [2] knob or the [1]–[16] buttons to select what to copy/paste.
MULTI-STEP
Copies the content of multiple steps from the step sequencer of the current part.
3. Press the [ä] button to execute the copy operation.
When the source is MULTI-STEP, the SELECT STEPS screen appears.
Use the [1] knob to select the starting step and the [2] knob to select the ending step number, and press the [ENTER] button
to execute the copy operation.