Roland SH-4d - Flanger)

MFX Parameters
106
SBF-325 (Flanger)
This effect reproduces Roland’s SBF-325 analog flanger.
It provides three types of flanging effect (which adds a metallic resonance to the original sound) and a chorus-type effect.
Parameter
Value
Explanation
Mode
Types of flanging effect
FL1
A typical mono flanger
FL2
A stereo flanger that preserves the stereo positioning of the original sound
FL3
A cross-mix flanger that produces a more intense effect
CHO
A chorus effect
Rate Sync
OFF, ON
If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System)(P.76)
Rate
0.02–5.00
[Hz]
Modulation frequency of the flanger effect
Rate Note
Note(P.167)
Depth
0–127
Modulation depth of the flanger effect
Manual
0–127
Center frequency at which the flanger effect is applied
Feedback
0–127
Amount by which the flanging effect is boosted
If Mode is CHO, this setting is ignored.
RMod
Phase
NORM, INV
Phase of the right channel modulation:
Normally, you will leave this at Normal (NORM).
If you specify Inverted (INV), the modulation (upward/downward movement) of the right channel
is inverted.
L Phase
NORM, INV
Phase when mixing the flanging sound with the original sound
NORM: normal phase
INV: inverse phase
R Phase
NORM, INV
Level
0–127
Output Level