Roland SH-4d - Mod Delay (Modulation Delay)

MFX Parameters
132
Parameter
Value
Explanation
DRTime
Nt
Note(P.167)
Phase L
NORMAL, INVERSE
Phase of left and right delay sound
NORMAL: Non-inverted
INVERT: Inverted
Phase R
NORMAL, INVERSE
Fbk Mode
NORMAL, CROSS
Selects the way in which delay sound is fed back into the effect. (See
the figures above.)
Feedback
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the
effect.
Negative (-) settings will invert the phase.
HF Damp
200, 250, 315, 400, 500, 630, 800, 1000, 1250,
1600, 2000, 2500, 3150, 4000, 5000, 6300,
8000, BYPASS [Hz]
Adjusts the frequency above which sound fed back to the effect is
filtered out. If you don’t want to filter out any high frequencies, set
this parameter to BYPASS.
Low Gain
-15–+15 [dB]
Amount of boost/cut for the low-frequency range
High Gain
-15–+15 [dB]
Amount of boost/cut for the high-frequency range
Balance
D100: 0W–D0: 100W
Volume balance between the direct sound (D) and the delay sound
(W)
Level
0–127
Output Level
Mod Delay (Modulation Delay)
Adds modulation to the delayed sound.
When Feedback Mode is NORMAL: