Sartorius Cubis MCA10202S Series User Manual

Cubis
®
MCA Operating Instructions 43
System Settings
7.4 Setting Up Device for Network Printer
7.4.1 Selecting Configuration for Network Printing
Two configurations are possible:
− The device and the network printer communicate via an independent Wi-Fi
network with standard Wi-Fi components. No security guidelines or network
settings need to be taken into consideration here. This configuration is recom-
mended if no other network functions are being used and simple printing is
enough.
− The device communicates with a company network via Wi-Fi. The network printer
is connected to the company network. All the device’s network functions can be
used in the entire company network. This configuration has 2 restrictions:
− The company network must have a DHCP server.
− Login via Wi-Fi only supports standard authentication methods and no special
security guidelines. This connection cannot be used in company networks
that require special security guidelines.
Procedure
t Check which configuration is suitable for network printing.
7.4.2 Setting Up Device for Network Printer via Independent Wi-Fi Network
Requirements
− The device administrator or service rights are activated via user management.
− The network printer is connected to a Wi-Fi router.
Procedure
t Check the suitability of the Wi-Fi router and Wi-Fi stick (for suitability, see
Chapter “16.1.1 Printers and Communication”, page 82).
t Insert the Wi-Fi stick into the device in a USB connection.
t Open the “Settings / Connections / Network / Wi-Fi” menu.
t Press the [Edit] button.
t Enter the service set identifier for the router under “Wi-Fi SSID”. The service set
identifier is specified on the back of the Wi-Fi router.
t Enter the router password under “Wi-Fi password”. The password is specified on
the back of the Wi-Fi router.
t Press the [Back] button.
y The status “Ready” appears in the “Wi-Fi” overview display within 10 seconds.
Creating a Network Printer
Procedure
t Open the “Settings / Connections / Connectors / YDP30-NET” menu.
t Press the [New] button.
t Enter a name for the network printer under “Connector name”, e.g. printer
YDP30-NET.
t Enter the network printer IP address under “IP or host”. The IP address of the
computer is specified in the network printer “Network Settings” printout.
t Confirm the entries. In order to do so, press the [OK] button.

Sartorius Cubis MCA10202S Series Specifications

General

Brand	Sartorius
Model	Cubis MCA10202S Series
Category	Scales
Language	English