Sartorius Cubis MCA10202S Series - Assembling and Connecting the Device; Maintenance Schedule; Performing a Software Update

68 Cubis
®
MCA Operating Instructions
Cleaning and Maintenance
9.3 Assembling and Connecting the Device
Procedure
t Replace the weighing pan and the associated components on the weighing
module (see Chapter “5.7 Positioning the Weighing Pan and Associated
Components”, page 39).
t Re-connect the device to the power supply (see Chapter 6.2, page 40).
9.4 Maintenance Schedule
Interval Component Action Chapter, page
Monthly to every 2 years, depending on
the operating conditions
Device Contact Sartorius Service 17, 84
9.5 Performing a Software Update
A software update can be installed from a USB mass storage device using the
device’s USB-A connection. A software update can extend or change functionality.
Requirements
− The device is switched on.
− The software update is saved on a USB mass storage device.
Procedure
t Download the software update from the Sartorius website onto the USB mass
storage device.
t If this relates to a zip file: Unzip the software update on the stick. The files must
be saved at root level. The files must not be set aside in a folder.
t Insert the USB mass storage device with the software update into one of the
device’s USB-A connection sockets.
t Select the “Update Firmware” menu entry in the “Settings / Device Maintenance”
menu.
t Select “USB stick” as the connector.
y The software update takes approx. 3 minutes.
y Once the software update is complete: The software version number is updated in
the login display.