58 Cubis
®
MCA Operating Instructions
Operation
8 Operation
8.1 Switching the Device On and Off
The device only delivers accurate values if it has reached the necessary operating
temperature. The warm-up time after switching the device on must therefore be
complied with.
If the device is being switched on for the first time or if the device is switched on
after being reset to factory settings: The Setup Wizard opens. All steps in the Setup
Wizard must be completed.
Requirements
The device is connected to the power supply.
Procedure
t If the device does not switch on automatically after it is connected to the power
supply: Press the ON key on the weighing module.
t NOTICE Pointed or sharp-edged objects may damage the operating display!
Touching the operating display with objects, such as pens, may damage the
touchscreen surface of the operating display. Only touch the operating display
with your fingertips.
t If the Setup Wizard is shown: Follow the instructions in the Setup Wizard in the
operating display.
t If the login display is displayed: Log into the device using a user profile.
y If the device is switched on after the Setup Wizard is complete and no passwords
have been assigned for the user profiles: The user profile for the last user to be
logged in is loaded.
t To allow the device to reach the necessary operating temperature to accurately
determine the weight: Comply with the warm-up time of 30 minutes after
switching the device on.
y If this relates to a conformity-assessed device: The weight value is marked as
invalid during the warm-up period.
t To switch the device off: Disconnect the device from the power supply.
8.2 Logging Users In and Out
Procedure
t If the name of the desired user profile is displayed in the entry field (1) of the
login display: Press the [Login] button.
t If the name of the desired user profile is not displayed in the entry field of the
login display:
t Tap on the entry field in the login display.
y The user selection opens.
t Press the name of the desired user profile.
t If a password has been assigned for the desired user: Enter the password in
the entry field and press the [OK] button.
y The user profile opens and the main menu or the last task being performed by
the active user is displayed.
t To log out the active user profile from the device: Press the [Log-out] button.
1
To Next Page
Loading...
Need help?
General