Sartorius Cubis MCA10202S Series - Date and Time Menu; Safe Weighing Menu

Cubis
®
MCA Operating Instructions 55
System Settings
7.5.15 Parameters in the “Device Settings / Date and Time” Menu
Parameter Settings Explanation
NTP configuration NTP operating status Activates or deactivates the time synchronization with the NTP server.
Server IP Saves the entered server ID for the NTP server.
Set the date and time Date format Sets the date display format to DD/MM/YYYY, MM/DD/YYYY, DD.MM.YYYY,
YYYY-MM-DD (ISO)*, YYYY:MM:DD, DD-MMM-YYYY or MMM-DD-YYYY.
Set date Saves the entered date.
Time format Sets the time display format to HH.MM.SS, HH:MM:SS (ISO)* or HH:MM:SS
am/pm.
Set time Saves the entered time.
Time zone Saves the selected time zone.
* Factory setting
7.5.16 Parameters in the “Device Settings / Safe Weighing” Menu
Parameter Settings Explanation
isoCAL execution
mode
Off Deactivates the isoCAL function. This setting change is not available for all
models.
Show status field, manual
start
If the device must be calibrated: The [isoCAL] button is displayed as the
predominant button in the operating display. The isoCAL function must be
manually triggered using the [isoCAL] button.
On, automatic execution* Activates the isoCAL function. The device is automatically adjusted as soon
as a trigger starts the isoCAL function.
On, automatic execution
with linearization (only if
possible)
Activates the isoCAL and linearization function. The device is automatically
adjusted and then linearized as soon as a trigger starts the isoCAL function.
Safety level Off If the isoCAL function must be carried out: The device displays a status
message.
Warning* If the isoCAL function must be carried out: The device displays a warning
message. Some device functions are limited until isoCAL has been
executed: The displayed weight value is marked as invalid; printed data are
marked with [!].
Strict If the isoCAL function must be carried out: The device displays an error
message. Some device functions are limited until isoCAL has been
executed: The displayed weight value is marked as invalid; the starting of
functions and saving of data in tasks is disabled; data output is
deactivated.
* Factory setting