EasyManua.ls Logo

SEW-Eurodrive MOVISAFE DCS B Series

SEW-Eurodrive MOVISAFE DCS B Series
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Manual – MOVIDRIVE® MDX61B Safety Module MOVISAFE® DCS..B Option
11
2
General information
Safety Notes
2 Safety Notes
The following basic safety notes must be read carefully to prevent injury to persons and
damage to property. The operator must ensure that the basic safety notes are read and
observed. Make sure that persons responsible for the plant and its operation, as well as
persons who work independently on the unit, have read through the operating
instructions carefully and understood them. If you are unclear about any of the informa-
tion in this documentation, or if you require further information, please contact SEW-
EURODRIVE.
2.1 General information
Never install or start up damaged products. Submit a complaint to the shipping company
immediately in the event of damage.
During operation, drive inverters can have live, bare and movable or rotating parts as
well as hot surfaces, depending on their degree of protection.
Removing covers without authorization, improper use as well as incorrect installation or
operation may result in severe injuries to persons or damage to property.
Refer to the documentation for additional information.
2.2 Target group
Only qualified personnel are authorized to install, start up, repair or service the units
(observe IEC 60364 or CENELEC HD 384 or DIN VDE 0100 and IEC 60664 or DIN VDE
0110 as well as national accident prevention guidelines).
Qualified personnel in the context of these basic safety notes are all persons familiar
with installation, assembly, startup, programming, parameterization and operation of the
product who possess the necessary qualifications. In addition to that, they must be
familiar with the relevant safety regulations and laws, especially with the requirements
of EN ISO 13849-1 and all other standards, directives and laws specified in this docu-
mentation. The persons mentioned must have the authorization expressly issued by the
company, to operate, program, configure, label and ground units, systems and circuits
in accordance with the standards of safety technology.
Any activities regarding transportation, storage, operation, and disposal must be carried
out by persons who have been instructed appropriately.

Table of Contents

Related product manuals