29
Adjusting and
Controlling
Multi
4 Set the Port Status.
If using the RS-232C connection, select the transmission speed
between the computer and the projector.
If using a LAN connection, input the projector’s IP address.
● Set the transmission speed here and confirm the transmission speed
on the projector to the same speed.
● For instructions on the projector’s transmission speed setting, refer
to the projector’s operation manual.
5 Select the projector model and check the “Use Projector”
check box.
6 Set the backup projector.
If necessary, set the backup projector. See page 56 for details.
7 Click the “Apply” button.
To Next Page
