Name: Sharp XG-P25X
Brand: Sharp
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Multi

Backup Function

This function automatically turns on the projector assigned in advance

as the backup projector, when the projector goes into standby due to a

malfunction.

When the backup projector autostarts, the settings of the projector in

which the error occurred are suitably sent to the backup projector,

therefore the interruption of the presentation is reduced to a minimum.

● This function can only be used when this software is running on a

personal computer.

● This function can only be used with the XG-V10 Series, the XG-P20X or

the XG-P25X.

● The backup projector will restart in the event of the following errors.

• Internal temperature error

• Cooling fan error

• Filter cover error

• Lamp burnout error

● The settings sent from the projector in which the error occurred to

the backup projector are as follows:

• The selected INPUT

• Signal Type information (RGB/COMPONENT/VIDEO)

• RESIZE information (Aspect ratio)

• Special Mode information

• Video System information

● Assign a projector that is normally in the standby mode as the backup

projector. Note that images other than the ones you expect may be

displayed when the backup function is activated if a projector that is

normally used is accidentally assigned as the backup projector.

Backup Function Settings

1 Select “Projector Setting” from the “File” menu.

1 Backup function enable/disable check box

2 Backup projector selection pull-down menu

Other manuals for Sharp XG-P25X

Questions and Answers:

Need help?

Do you have a question about the Sharp XG-P25X and is the answer not in the manual?

General