57
Adjusting and
Controlling
Multi
2 Make the settings for the projector for the side to be
backed up.
Refer to page 58 to make the settings for the projectors to be backed
up.
3 Check the “Backup function enable/disable check box”.
4 Select the projector to be assigned as the backup projector.
Select the projector from the projector selection pull-down menu.
5 Click the “Apply” button.
Interval Time Setting
With this software, the projectors’ internal data is collected periodically at
preset intervals so that the backup function can work. Set this interval here.
1 Select “Configuration” from “Control Option”.
2 Select the desired interval in “Backup interval” on the
“Configuration” window.
3 Click the “OK” button.
When several projectors have been set to be backed up, the data of
one projector will be collected in order at each backup interval that
is set in advance.
For example, if the backup interval has been set to 5 minutes and 3
projectors have been set to be backed up, the data of the first
projector will be collected. After 5 minutes have elapsed, the data of
the second projector will be collected. Again after 5 minutes, the
data of the 3rd projector will be collected. 5 minutes later, the data of
the first projector will be collected again and the data collection
procedure will repeat itself as above.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
