66
Single Multi
“Fine Sync” Adjustment
E. g. The display below is the one that appears when used with the XG-
C50X projector.
You can perform the adjustments, settings or functions below on this
sheet:
Clock, Phase, H-POS, V-POS, Auto Sync Setup ON/OFF, Special
Modes, Auto Sync Display ON/OFF, Save No., Select No.
● Some items may not be controlled depending on the projector
model to be controlled.
● Refer to the projector’s operation manual for details on each
adjustment.
● “Fine Sync” adjustment is not necessary except “Auto Sync
Setup” and “Special Modes” with Input3 (DVI) mode when using
the DVI digital RGB input terminal. (The “Input Adjust” and
“Settings” items cannot be adjusted.)
● Make a note of the “Save No.” and its stored setting, if necessary.
You cannot check each setting with this software after saving it.
● The previous setting will be overwritten if you save on the same
“Save No.” button.
To Next Page
Loading...
