77
Adjusting and
Controlling
Single
The “Reset & Transmit” button resets the values of the color
currently selected. If you want to reset both the red and green
values, click the “Reset & Transmit” button in the “RED” mode,
and then click the “Reset & Transmit” button again in the
“GREEN” mode. If you want to reset to the original values, click
the “Reset & Transmit” button in the “WHITE” mode.
3 To restore to the previous status after operating the gamma data.
4 To restore the status before the “UNDO” button was clicked.
5 To send all the adjustment signals to the projector
6 Gamma coordinate display (INPUT/OUTPUT)
2 Select the “InputMode”.
3 Adjust the values of each color.
Drag and drop the curve of the graph to adjust it to the proper value.
4 Click “Transmit”.
| The “Now Transmitting...” message is displayed during
transmission.
To Next Page
