Shimadzu GC-2014 Service Manual

Chapter 1 Installation
GC-2014 Service Manual
6
1.2.2 Installation Surface
Install the instrument on a steady, stable, flat surface.
1.2.3 Corrosive Gas and Dust
In order to attain the specified service life and maintain performance specifications, do
not install the instrument in locations subject to large amounts of corrosive gas or dust.
1.2.4 Influence of Electromagnetic Waves and Power-Supply Noise
Do not use this instrument in locations subject to strong electromagnetic waves or use
with power supplies that generate high noise levels. Doing so may result in malfunction
and it may not be possible to obtain data that conforms to specifications.
1.2.5 Other Precautionary Items
In order to maintain performance specifications, give due consideration to the following
points.
(1) Changes in the ambient temperature during operation must be kept to a minimum.
(2) The instrument must not be directly exposed to the airstream emanating from
heating or cooling equipment.
(3) The instrument must not be exposed to direct sunlight.
(4) Vibrations must be kept to a minimum.

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)