Shimadzu GC-2014 Service Manual

Chapter 4 Sample Injection Unit
GC-2014 Service Manual
47
4.3 Configuration of Injection Unit
GUIDE, FOR NEEDLE FIN AOC
S221
-
41286
SEPTUM NUT
RUBBER PLUG, INJ PORT, SILICONE
Separate P/N for maintenance
INJECTION PORT P ASSY
(Shaded area)
CARRIER/PURGE LINE
INSULATOR, UPPER
SPLIT LI
NE
BASE, INJECTION UNIT A ASSY
(Shaded area)
PARALLEL PIN,
SUS1.6

4
INSULATOR, SPL
HEATER BLOCK, SPL
HEATER, PT ASSY, SPL100
(HEATER, PT ASSY, SPL230)
NUT, M10
NUT, MF
WASHER, MM
NIPPLE, FOR GASKET
0
to 2
mm

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)