Shimadzu GC-2014 - Power Supply; Power-Supply Voltage; Power-Supply Capacity

Chapter 1 Installation
GC-2014 Service Manual
7
1.3 Power Supply
WARNING

High Voltage

Before connecting the power cable directly to the terminal block in the
switchboard, be sure to turn OFF the switchboard switch.

Be sure to supply power from a power supply incorporating a circuit breaker.

Do not place heavy objects on the power cable.
Check the following points before connecting the power supply.
1.3.1 Power-Supply Voltage
In order to maintain performance specifications, use a power supply that falls within the
following specified power-supply voltage ranges.
100-V AC specifications 115-V AC specifications 230-V AC specifications
Specified
power-supply
voltage
95 to 105 V AC
50/60 Hz
110 to 120 V AC
50/60 Hz
219 to 241 V AC
50/60 Hz
Operating
power-supply
voltage
90 to 110 V AC
50/60 Hz
104 to 126 V AC
50/60 Hz
207 to 253 V AC
50/60 Hz
1.3.2 Power-Supply Capacity
Calculate the power-supply capacity by totaling the power consumption for each of the
following parts. Connect the instrument to a terminal with a sufficient capacity.
Unit Power consumption
Standard model equipped with TCD FID 1,850 VA (100-V model) or 2,650 VA
(230-V model)
Additional temperature-control block (e.g., INJ) 150 VA or 200 VA (dual FID and TCD only)
NOTE
 The instrument will not attain its performance specifications if the power-supply
voltage is unstable or if the power-supply capacity is insufficient.