SICK MLG-2 WebChecker

Designation Description
Input function Select input function.
•
Input is no
t used. Value of this function is always 0
•
Universal teach-in: Short input signal for material teach-in, long
signal for sensor teach-in
•
Run sensor teach-in if the input is active
•
Run material teach-in when input is active
•
Activated green mode if input is active
•
Trigger data interface with digital input
Output function Select output function
•
Output is no
t used Value of this function is always 0
•
Qint configuration
•
Alarm for process quality (QoR)
•
General alarm
•
Alarm when edge x is not available
Only with output function = Qint configuration:
Task Select edge or function.
Opt
ions: Edge 1 to edge 10 and function 1 to 10
Mode
•
T
hr
eshold mode
•
Window mode
Switching point 1 Enter switching point 1 in mm.
Switching point 2 Prerequisite: Parameter “mode”: Window mode
Ent
er s
witching point 2 in mm.
Teach-in value Shows the measured value for material teach-in for the selected
edg
e or function. You can select the edge or function via the “Out‐
put” parameter.
Switching point 1/2 Depending on the selected mode.
Inverted I/O Inverted input or switching output.
Examples for digital configuration
An are
a should be monitored in which an edge is passing.
1. Define Qx as the switching output.
2. Set Qx to "Qint configuration".
3. Set the mode to “Window mode”.
4. Select the edge to be monitored under “Task”.
5. Enter values for switching point 1/2 which are larger/smaller than the edge posi‐
tion.
✓
As soon as the edge is within the area, the “1” value is output.
11 CONFIGURATION WITH SOPAS
104
O P E R A T I N G I N S T R U C T I O N S | MLG-2 WebChecker 8025190/2020-01-13 | SICK
Subject to change without notice