C-1
Programmable Logic Controllers S7-300 Module Data
A5E00105505-03
Dimension Drawings
Introduction
In this appendix you will find the dimension drawings for the most important
components of an S7-300. The specifications in these dimension drawings are
required for dimensioning the S7-300 configuration. The dimensions of an S7-300
configuration must be taken into account when installing an S7-300 in cabinets,
switchgear rooms, etc. This appendix does not contain any dimension drawings of
the CPUs of the S7-300 or M7-300 or of the IM 153-1. These dimension drawings
are contained in the relevant manuals.
Contents
In this appendix, you will find the dimension drawings of the following S7-300
components.
Section Contents Page
C.1 Dimension Drawings of the Rails C-2
C.2 Dimension Drawings of the Power Supply Modules C-8
C.3 Dimension Drawings of the Interface Modules C-13
C.4 Dimension Drawings of the Signal Modules C-13
C.5 Dimension Drawings for Accessories C-15
C
To Next Page
Loading...
Need help?
General
