Changing and expanding the FDnet/C
Removing or replacing non
12
52 | 178
12.4.2.1 Temporarily removing an individual non-stationary device
Instances may arise when a C-NET device has to be temporarily removed from the
base. Afterwards the same device must be re-inserted at exactly the same place in
the C-NET.
Mark the allocation of the devices to the respective base to avoid additional work
steps.
You will find additional information about the individual
pages.
1. Switch the C-NET detector line off. Link [➙ 79]
2. Remove the C-NET device from its base.
3. Perform the tasks.
4. Re-insert the C-NET device in the corresponding position.
5. Switch the C-NET detector line on. Link [➙ 79]
If detectors have been swapped over or are missing, the following messages are
shown on the display of the Person Machine Interface:
'Zone', 'Serial no. ("ID-Nr.")', 'Dev.location fault'
See also
2 Correcting swapped devices [➙ 158]
12.4.2.2 Replacing non-stationary devices of the same type
You will find additional information about the individual steps on the specified
pages.
1. Switch the C-NET detector line off. Link [➙ 79]
2. Replace the C-NET device with a device of the same type. Several devices can
be replaced.
3. Rectify localization errors. Link [➙ 86]
4. Connect the PC to the 'Station'. Link [➙ 27]
5. Load the configuration from the 'Station' to the PC. Link [➙ 32]
6. Disconnect the PC from the 'Station'. Link [➙ 27]
To Next Page
Loading...
