Siemens SIMATIC IPC RW-545A

To Next Page

To Previous Page

Commissioning the device

5.1 Switching on the device

Requirement

• The power supply unit is connected. (Page 58)

Procedure

1. For devices with power supply unit 550 W and power supply unit 850 W:

Switch on the on-off switch on the rear of the device (position | ).

2. Press the on-off button on the front side of the device behind the front door.

Information on the position of the switch and the button is available under "Operator

controls (Page 24)".

Commissioning the installed Windows® operating system

You can find information on the first switch on of the device and on commissioning the

installed Windows® operating system in the documentation of your operating system, see

"Important instructions and manuals for operating the device (Page 11)".

5.2 Configuring automatic switch-on of device

In the firmware settings, you can specify that the device starts up again automatically after

being disconnected from the mains voltage for up to two minutes as soon as the mains

voltage is available again.

The minimum downtime required for the mains voltage depends on the configuration of the

device.

Configure this function in the firmware settings:

1. Select: "Advanced > Power Management > Restore AC after Power Loss".

2. Assign the "Always on" value to the firmware setting "Restore AC after Power Loss".

Related product manuals