Operating the device
6.6 Remote maintenance of the device
89
6.6.2.5 Configuring the AMT functions in the options of the MEBx
Use "Intel® Management Engine BIOS Extension" (MEBx) to configure important firmware
settings of your device to use Intel® AMT functions and the Intel® Management Engine (ME).
The following options are available for Intel® AMT-enabled devices:
• Redirection features
• User Consent
Password Policy
• Network Setup
Network Access State
• Remote Setup And Configuration
• Power Control
Requirement for the use of "Intel® Management Engine BIOS Extension" (MEBx)
• The device is logged into MEBx (Page 88)
Procedure
You can find information on the configuration of the Intel® AMT functions in the options of
the MEBx in the User Manual (UM) for the motherboard, see "Important instructions and
manuals for operating the device (Page 11)".
6.6.2.6 Reset Intel® AMT functions to default settings and disabling iAMT
One effect of resetting to the default settings is that Intel® AMT is disabled.
1. Switch on the device or restart it.
2. Immediately after turning on the device, as soon as the message "Press <DEL> or
<ESC> to enter setup" appears, press and hold the <Del> or <Esc> button.
The firmware user interface opens. Here you have the following keys available for
navigation:
• Select entry (then confirm selection)
• Arrow keys on the keyboard
• Confirm selection • <Enter> key
• Back to previous window
3. Select "Advanced" > "AMT Configuration".
4. Assign the "Enabled" value to the firmware setting "Unconfigure ME".
5. Press the button <F4> (Save & Exit Setup) and confirm the subsequent dialog with <Y>.
6. Switch off the device or restart the device.
Workstation SIMATIC IPC RW-545A
Operating Instructions, 08/2023, A5E52943278-AA
To Next Page
Loading...
