Siemens SIMOCODE pro - Page 231

Tables, data records
3.4 Tables, PROFINET data records
SIMOCODE pro - Communication
Function Manual, 11/2018, A5E40508495002A/RS-AC/003
231
Byte.Bit
Designation
Information
PNIO
diagnostic
status **)
PNIO error
number (channel
error type)
Error no.
8.5
Event - Trip U<
UM(+)
8.6 Event - Trip 0/4-20 mA> AM1
8.7
Event - Trip 0/4-20 mA<
AM1
9.0
Event - Stalled rotor
IM UM(+)
9.1 Events -
Protection
Warning - Internal ground fault UM+
9.2
Reserved
9.3 Events - Level
monitoring
Event - No start possible
9.4
Event - No. of starts >
9.5
Event - Just one start possible
9.6 Event - Motor operating
hours >
9.7
Event - Motor stop time >
10.0
Event - Limit 1
10.1
Event - Limit 2
10.2
Event - Limit 3
10.3
Event - Limit 4
10.4 Events -
Miscellaneous
Event - ext. fault 1
10.5
Event - ext. fault 2
10.6
Event - ext. fault 3
10.7 Event - ext. fault 4
11.0
Event - ext. fault 5
11.1 Event - ext. fault 6
11.2 Events - FW
update
Event - BU FW update active
11.3 Event - Module FW update
active
11.4 Events -
Miscellaneous
Event - AM1 open circuit AM1
11.5 Event - DM-F safety-related
tripping
DM-F
11.6 Event - DM-F - Test
requirement
DM-F
11.7
Event - NTP clock set
12.0 Events -
Timestamping
function
Event - Timestamping function
active + OK
12.1 Events -
Miscellaneous
Event - NTP clock
synchronized
12.2
Event - DM-FL safety ok
DM-FL