Siemens SIMOCODE pro - Page 232

Tables, data records
3.4 Tables, PROFINET data records
SIMOCODE pro - Communication
232 Function Manual, 11/2018, A5E40508495002A/RS-AC/003
Byte.Bit
Designation
Information
PNIO
diagnostic
status **)
PNIO error
number (channel
error type)
Error no.
12.3 Event - DM-FP PROFIsafe
active
DM-FP
12.4 Events - System
interfaces
Event - Configured operator
panel missing
12.5
Event - Module not supported
12.6
Event - No module voltage
12.7
Reserved
13.0 Events - Memory
module /
initialization
module
Event - Memory module read in
13.1 Event - Memory module
programmed
13.2 Event - Memory module
cleared
13.3
Reserved
13.4 Event - Initialization module
read in
13.5 Event - Initialization module
programmed
13.6 Event - Initialization module
cleared
13.7 Reserved
14.0 Events -
parameterization
Event - Start-up parameter
block active
***)
14.1 Event - Parameter changes not
allowed in the
current operating
state
1 0x0010
14.2 Event - Device does not
support the required functions
1 0x0010
14.3
Event - Wrong parameter
1
0x0010
14.4
Event - Wrong password
1
0x0010
14.5 Event - Password protection
active
14.6
Event - Factory settings
14.7
Event - Parameterization active
15.0 Event - PRM error number
(bytes)
16.0 Event - DM-FL configuration
mode
16.1 Event - DM-FL configuration
deviation
16.2 Event - DM-FL waiting for
start-up test
16.3 Event - DM-FP F-Prm error *) 3 0x0010